Fully functional CAN – BUS network system is installed in a mobile aluminum frame. This CAN BUS training board is specially designed to help technical students understand the system`s construction.
The educational training board is based on OEM components of Mercedes – Benz. The stand is equipped with a functional CAN GATEWAY 2.0 system.
The training board-simulator is a great educational tool that allows students to learn the structure of CAN gateway system, study its components, and perform various measurements, tests and other diagnostic procedures.
Technical specifications and functions
The training board is equipped with a CAN gateway 2.0 network system that includes:
– Dashboard
– Engine ECU
– Smart Key, ignition module, lock module
– SRS Airbag ECU
– Central CAN Gateway module (ECU)
– Front and rear doors control modules
– Front and rear windows lifting motors
– Front and rear windows lifting switches
All the components are connected to the internal network. The Network is shown as a diagram in order to understand better;
The modules communications can be connected or disconnected by banana plug jumpers. Low and High speed CAN lines can be disconnected on the stand;
CAN getaway diagram with built in banana plug jumpers for measurements and simulation of system malfunctions;
Ability to simulate more than 10 system faults;
The window lifting motors are active and controlled by a switches and doors control modules through CAN gateway network of the car;
Diagnostic and measurement
Oscilloscope/multimeter
System’s parameters are measured by connecting to the banana connector
Ability to measure electrical signal parameters of system component
Control unit diagnosis
Diagnosis through OBD 16 – pin diagnostic connector
Diagnose all presented control units in the CAN bus network by using an automatic search (depending on the diagnostic tool possibilities)
Diagnose of each control module separately
Electronic control unit (ECU) identification
Reading/erasing fault codes
Displaying the operating system parameters (live data)
Activating the actuators (depends on the control unit)
Control unit encoding/configuration (depends on the control unit)
Other
The stand has a closed structure – internal wiring is not visible
Power supply: 12V from the battery (not included as standard accessory)
Dimensions approx.: (HxLxW) 1820x1360x500 mm
Nett weight approx.: 60 Kg
Made in EU
CE certificate
Optional accessories
12 V battery
220/12 V Power supply unit
Automotive oscilloscope
CAN Network analyzer
OBD diagnostic scan tool